How to deal with CNC table plasma cutting machine problems in programming?

table plasma cutting machine

This article is from SteelTailor blog:https://www.steeltailor.com/blog/deal-cnc-table-plasma-cutting-machine-problems-programming/

1.CNC table plasma cutting machine program can’t be read.

Plamsa cutting machine program naming error. The naming can’t be accompanied by Chinese characters.

No two “.” numbers can appear in table plasma cutting machine program name.

CNC cutting machine program name is too long.

U disk contact bad.

2.CNC plasma cutting machine programming software can not be open or open too slow.

Plasma cutting machine software working for long time. It procedures derived too much waste files and should be liquidated or re-installed

Table plasma cutting machine system defects or desktop files opened too much.

3.Some graphics changed color when CNC plasma cutting machine program be put out.It will seriously affect the cutting and damage the work-piece.Plasma cutting machine software output is garbled.Change graphics code manually. If you cannot fix it, you can also write the output again.

4. When programming, we must pay attention to CNC cutting machine sheet size. Unilateral to have 10mm cutting allowance.

SteelTailor LegendB5II CNC table plasma cutting machine is an powerful CNC plasma cutting machine with marking function.

https://www.steeltailor.com/blog/yeahlegendb5ii-cnc-table-cutting-and-marking-machine/